This document contains information on installing HiJaak Graphics 
Suite on systems with the following configurations: compressed 
drives; shared Windows installation on a network drive; systems 
using SuperStor 1.0, Stacker 1.0 or Norton Desktop for Windows. 
Finally, it contains information on using a modem during install 
and instructions for deinstalling HiJaak Graphics Suite.
__________________________________________________________________

INSTALLING TO A COMPRESSED DRIVE
If you are installing HiJaak Graphics Suite to a drive that has 
been compressed using a program such as Stacker, DoubleSpace or 
SuperStor, you may experience problems if the drive does not have 
significantly more free space than the install requires. 
Compression programs calculate the amount of available space based 
on how much the files will be compressed; they do not calculate 
the actual amount of free space. Since some HiJaak Graphics Suite 
files might not compress as much as the compression program 
calculates, there may not be enough space on the drive. For more 
information, refer to your drive compression software's documentation.
__________________________________________________________________

INSTALLING ON SHARED NETWORK WINDOWS INSTALLATIONS
If you are sharing a Windows installation on a network drive, you 
may not have write rights to the WINDOWS and WINDOWS\SYSTEM 
directories. If you do not have write rights to these directories,
you will NOT be able to install HiJaak Graphics Suite. Contact 
your network administrator and have him or her either install the
software for you or give you write rights to these directories so 
you can perform the installation.
__________________________________________________________________

USING SUPERSTOR 1.0
The installation software used in HiJaak Graphics Suite is not
compatible with SuperStor version 1.0. If you are using this
version of SuperStor, either install HiJaak Graphics Suite to
an uncompressed drive or update your SuperStor to at least
version 2.0.
__________________________________________________________________

USING STACKER 1.0
The installation software used in HiJaak Graphics Suite is not
compatible with Stacker version 1.0. If you are using this
version of Stacker, either install HiJaak Graphics Suite to
an uncompressed drive or update your Stacker to at least
version 2.0.
__________________________________________________________________

USING NORTON DESKTOP FOR WINDOWS
The installation of HiJaak Graphics Suite may move the Startup
group on your desktop when it finishes, whether or not you chose 
to put the Smuggler icon in the Startup group. All you
need to do is move the group icon back where you normally keep
it.
__________________________________________________________________

USING A MODEM DURING INSTALL
If you are not a pre-registered user of HiJaak Graphics Suite,
then the Install will prompt you to register by modem. Therefore, it 
is recommended that you end any modem connections before installing
HiJaak Graphics Suite.

__________________________________________________________________

A NOTE ABOUT DEINSTALLING HIJAAK GRAPHICS SUITE
HiJaak Graphics Suite installs certain DLL and other support
files in order to operate. Some of these files may have already
been present because they are used by other Windows
applications you may have installed.  In this case, removing
the files would cause those other applications to stop operating
correctly.  For this reason, deinstalling HiJaak Graphics Suite
intentionally does not remove these support files.